Arcoaire AC Single Phase Split System Deluxe Single Stg 4 Ton 60k BTU Coil 96Pct Furnace 120 MBH 14.5 SEER2 V1

• 80% AFUE
• Flame roll-out sensors standard
• Category I venting
• Blocked vent switch
• Louvered door
• 24 VAC and 115 VAC humidifier terminal
• Electronic air cleaner terminal
• Select sizes approved for twinning, refer to accessory kit listing
• N80ESL - Low NOx units are designed for California installations and can be installed in air quality management districts with a 40ng/J NOx emissions limit
• Cabinet air leakage less than 2.0% at 1.0 in. W.C. and cabinet air leakage less than 1.4% at 0.5 in. W.C. when tested in accordance with ASHRAE standard 193
• Adjustable heating blower OFF delay
• Factory set blower ON delay
• RPJ aluminized steel heat exchanger
• High temperature limit control designed to prevent overheating
• Direct ignition with Silicon Nitride igniter
• One piece prepainted steel cabinet
• In-shot burners
• 33 1/3” (847mm) high, for ease of installation
• Quarter turn knobs for easy door removal and secure attachment
• Factory shipped for natural gas, convertible to propane with accessory kit
• Four position - upflow/downflow/horizontal (left/right) installation
• Three position inducer elbow capability
• Through the casing flue pipe for counterflow applications
• Common venting with other Category I appliances
• Masonry chimney adapter available
• Self diagnostics
• Slide out blower assembly

Gas Furnace

• Two-stage heating operation
• Two-speed induced draft combustion blower
• Supports single- and two-stage cooling units
• Dehumidification feature (A/C)
• Fully insulated steel cabinet
• Certified to leak 2% or less of nominal air conditioning CFM delivered (when pressurized to 1 inch water column with all present air inlets, air outlets, and condensate drain port(s) sealed)
• VCT Variable Speed Constant Torque Motor
• Aluminized steel RPJ primary heat exchanger
• Stainless steel secondary heat exchanger
• Direct ignition with Silicon Nitride ignitor
• Direct vent (2-pipe), single-pipe venting, or ventilated combustion air
• 35” (889mm) high , for ease of installation
• Four position - upflow/downflow/horizontal (left/right) installation
• At least twelve different venting configurations
• Through the casing flue pipe for counterflow or horizontal applications with accessory (order separately)
• Self-configuring and communicating control
• Concentric vent available
• Twining Capable (select size) w/ kit

• Corrosion Resistant Aluminum
• Low Pressure Drop
• TXV metering device factory installed
• Compact design, shorter than A-coils
• Hemmed flanges for safer handling
• Cabinets meet or exceed 2% air leakage codes
• UV knockout
• No delta plate allows easy cleaning
• 30-40% Lighter than “A” Coils
• 80% Fewer Factory Braze Joints vs. “N” Coils
• V Design Reduces Cabinet Sweating
• Helium leak tested @ the factory